moved custom settings to my_config.h

src/my_config.h

@@ -0,0 +1,46 @@
+/*
+ * my_config.h
+ * All configurations and customization's go here
+ * 
+ * Paul Derbyshire - https://github.com/proddy/EMS-ESP-Boiler
+ */
+
+#pragma once
+
+// these are set as -D build flags during compilation
+// they can be set in platformio.ini or alternatively hard coded here
+
+// WIFI settings
+//#define WIFI_SSID "<my_ssid>"
+//#define WIFI_PASSWORD "<my_password>"
+
+// MQTT settings
+// Note port is the default 1883
+//#define MQTT_IP "<broker_ip>"
+//#define MQTT_USER "<broker_username>"
+//#define MQTT_PASS "<broker_password>"
+
+// default values
+#define BOILER_THERMOSTAT_ENABLED 1 // thermostat support is enabled (1)
+#define BOILER_SHOWER_TIMER 1       // monitors how long a shower has taken
+#define BOILER_SHOWER_ALERT 0       // send alert if showetime exceeded
+
+// define here the Thermostat type. see ems.h for options
+#define EMS_ID_THERMOSTAT EMS_ID_THERMOSTAT_RC20 // your thermostat ID
+
+// trigger settings to determine if hot tap water or the heating is active
+#define EMS_BOILER_BURNPOWER_TAPWATER 100
+#define EMS_BOILER_SELFLOWTEMP_HEATING 70
+
+// if using the shower timer, change these settings (in ms)
+#define SHOWER_PAUSE_TIME 15000    // 15 seconds, max time if water is switched off & on during a shower
+#define SHOWER_MIN_DURATION 180000 // 3 minutes, before recognizing its a shower
+#define SHOWER_MAX_DURATION 420000 // 7 minutes, before trigger a shot of cold water
+#define SHOWER_COLDSHOT_DURATION 5 // 5 seconds for cold water - note, must be in seconds
+#define SHOWER_OFFSET_TIME 8000    // 8 seconds grace time, to calibrate actual time under the shower
+
+// if using LEDs to show traffic, configure the GPIOs here
+// only works if -DUSE_LED is set in platformio.ini
+#define LED_RX D1  // GPIO5
+#define LED_TX D2  // GPIO4
+#define LED_ERR D3 // GPIO0