andry/EMS-ESP32
1
0
Fork 0
mirror of https://github.com/emsesp/EMS-ESP32.git synced 2026-10-28 11:14:58 +00:00
Code Issues Packages Projects Releases Wiki Activity

another fix for #3283

Browse Source
This commit is contained in:
proddy
2026-10-13 18:37:39 +02:00
parent e9bb68eeb5
commit bbacd7021a
4 changed files with 7 additions and 4 deletions
Download Patch File Download Diff File Expand all files Collapse all files
CHANGELOG_LATEST.md
+1 -1
View File
@@ -55,7 +55,7 @@ This release is based on the latest Espressif/Arduino core version 3. It brings
- show temperature value for sensor 0x40 [#3272](https://github.com/emsesp/EMS-ESP32/issues/3272)
- no EMS bus on custom boards whose interface relies on a pull-up on the Rx line. The newer ESP-IDF no longer enables the internal pull-up on the UART Rx pin, so it is now set explicitly as it was in 3.8 [#3258](https://github.com/emsesp/EMS-ESP32/discussions/3258)
- no EMS bus after restart when Rx uses a pin that boots with another IO_MUX function (e.g. GPIO43/44 = UART0 on ESP32-S3). IDF 5 `uart_set_pin()` no longer selects the GPIO function on the Rx pad when routing via the matrix, so the pin is reset before UART setup [#3258](https://github.com/emsesp/EMS-ESP32/discussions/3258)
- Tx mode Auto preferred HT3 pacing over EMS+ when the bus used the HT3 address mask. Some Bosch heat pumps (e.g. Compress 7000i AW, CS5800i) need EMS+ timing; Auto now prefers EMS+ when EMS 2.0 telegrams are seen [#3283](https://github.com/emsesp/EMS-ESP32/issues/3283), [#3245](https://github.com/emsesp/EMS-ESP32/issues/3245)
- Tx mode Auto preferred HT3 pacing over EMS+ when the bus used the HT3 address mask. Some Bosch heat pumps (e.g. Compress 7000i AW, CS5800i) need EMS+ timing; Auto now selects EMS+ when boiler monitor 0xE4 is seen (not merely any extended telegram, which Junkers HT3 also uses) [#3283](https://github.com/emsesp/EMS-ESP32/issues/3283), [#3245](https://github.com/emsesp/EMS-ESP32/issues/3245)
- Guru Meditation (cache error) on HybridCompile builds when the EMS or console UART ISR ran from flash during a SPI flash read (WiFi power-down, mDNS, NVS). The UART ISR and ringbuf ISR helpers are now in IRAM
- compile errors against Arduino 3.3.12 from Tasmota/Arduino headers named `console.h`, `network.h` and `httpClient.h`. Those EMS-ESP headers are now `emsesp_console.h`, `emsesp_network.h` and `emsesp_http_client.h`
- HTTP OTA from WSL/mDNS stalled on IPv6 and used tiny write chunks. Uploads now resolve IPv4 and stream in 64 KB blocks (`scripts/upload.py`, `scripts/upload_cli.py`)