° added markers (GIO12, GPIO14) for logic analyzer debugging
° change UART initialisation
- set RxFIFO full to 1 char, so we can detect active telegram on EMS-Bus
- set RxTOT to 1 char for the same reason
° in ems_parseTelegram: ignore telegram if emsRxStatus != EMS_RX_STATUS_IDLE
because we missed to respond in a timely manner
° ems_tx_buffer is not void anymore, instead we return the Tx status
° extended the emsTxStatus
- EMS_TX_WTD_TIMEOUT: timeout while waiting for echo of last Tx byte
out telegram was ignored by the bus master, so the byte wasn't echoed
- EMS_TX_BRK_DETECT: BRK detected while sending the telegram
bus master send us a break because of protocol violation
° add burnStarts, burnWorkMin and heatWorkMin to MQTT boiler message
TODO:
+ take care of ems_tx_buffer return code
+ accept direct telegram in ems_parse_telegram and do a proper acknowledge
+ split the heartbeat in static (version, IP-address) and dynamic (RSS etc)
+ change the hearbeat to a JSON structure so we can easier pick the uptime
- fix typo - replace emsaurt_tx_poll by emsuart_tx_poll
- smart tx - enabled by EMS_Sys_Status.emsTxDelay == 2
use loopback to send in burst mode
- change emsuart_tx_poll to use emsuart_tx_buffer
- encapsulate uart_swap in #ifndef NO_UART_SWAP (private use)
